1/2/2005
1:00		Power Cycling of Science Flight Computer	JH
1:28		ask ESC to turn off Science cpu	JH
2:03		ask ESC to turn on Science cpu	JH
4:15		resetting DAQ	JH
4:29		restarting DAQ	JH
8:06		SCI_MTR_BUSY_DISABLE 0x1F timestamp is working->it's updated
		sent command string *C0C020000000C
		click butten "test mode" in cdps1 GUI
10:50		Larry suggest these commands	YS
		SCI_MTR_CAL_PRESCALE 0x1FF
		SCI_MTR_ZHI_PRESCALE 0x1FF
		SCI_MTR_ZLO_PRESCALE 0x1FF
		SCI_SW_CAL_PED_UPDATE_RUN 100
		>>> ERROR: master tirgger : no data after 20000001 attempts
11:29		Rebooting SFC again.	YS
12:20		ESC set up for Iridium commanding connection	YS
		SCI_SW_SELECT_EVENT 1, 0xB8
		SCI_MTR_CAL_PRESCALE 0
		SCI_MTR_ZHI_PRESCALE 0
		SCI_MTR_ZLO_PRESCALE 0
		DAQ_RESET
		sent command string *C0C020000000C
		Send "flight mode"
		Still ERROR messgae
12:25		Turn on LED for CAL	YS
		SCI_CAL_LED_PULSE ON
		There was current increase in housekeeping.
		SCI_CAL_LED_PULSE OFF
		sent command string *C0C0200000004
		SCI_MTR_COMMAND_TRIG
		sent command string *C0C0200000001
		After discussion of ES, Larry, Sonny and MooHyun, we are planning to turn off All detectors and turn back on them	YS
12:50		Send commands for ramping down CAL,HDS and SCD.	YS
		Send commands for power off CAL, HDS and SDC
1:05		ESC made connection for commnading using Iridium	YS
		Send commands for HV off for TRD
1:27		I asked ESC to power of CAL,HDS,SCD, TCD and TRD	YS
		ESC powered off CAL, HDS, SCD, TCD and TRD	YS
1:40		ESC powred off SFC
		ECS powered on SFC in 3 minutes
		ESC powered on CAL, HDS, SCD, TCD and TRD	YS
2:00		Check Mater trigger and Calorimeter and click test mode
		And then, we see the trigger rate response… Great!!!	YS
		Send commands of settings for TCD
		Send commands of HV on for TRD
		Send commands of HV on for CAL, HDS and SCD	YS
2:40		Ramping is done
		SCI_SPARE1 0
		send commands for CAL trig threshold of 75	YS
		"arc_start.stol"
		SCI_SPARE0 0
		Send "daq_restart.stol"
		Now, trigger comes back.. (ZHI=20Hz and CAL1.2 Hz)